Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
194 Posts
Discussion Starter #1
imported post

I think I need to add a relay to my 1200. The horn works well with the engine off or at higher RPMS when on. I also am going to start switching over to LED lights a few at a time. But where can I get a relay? What am I really looking for? My charging system is good. Thanks!



Duban
 

·
Junior Grue
Joined
·
8,153 Posts
imported post

Duban wrote:
I think I need to add a relay to my 1200. The horn works well with the engine off or at higher RPMS when on. I also am going to start switching over to LED lights a few at a time. But where can I get a relay? What am I really looking for? My charging system is good. Thanks!



Duban
Are you sure the charging system/battery is good?
Unless your running lots of extras the voltage at the battery should be higher idling than with the bike not running.
 

·
Premium Member
Joined
·
3,965 Posts
imported post

also check the four prong plug at the soleniod mine came loose the bike would run

but binkers work slowly i put in a amp gauge in and it was pushing 16 amps push the plug

back on and everything go back to normal
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top