Steve Saunders Goldwing Forums banner
1 - 2 of 2 Posts

·
Registered
1988 Honda GL1500
Joined
·
692 Posts
Flexible hose collapsing or more likely the master needs rebuilding, there is a very tiny hole that if blocked causes pressure to be held in the system
 

·
Registered
1988 Honda GL1500
Joined
·
692 Posts
On this cylinder specifically no, but there are usually two holes from fluid reservoir to operating bore one larger one closer to the pivot and one tiny one closer to the outlet end.
The tiny one is so small that most people dont believe its there looks just like an unfinished drill hole.

Only way i know off to clean properly is strip out the seal and piston and replace
 
1 - 2 of 2 Posts
Top