Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Premium Member
Joined
·
24 Posts
Discussion Starter · #1 ·
imported post

Can somebody give me the torque specs for the exhaust headers on GL1200i? I can't find them in my Clymers manual.
 

·
Premium Member
Joined
·
24 Posts
Discussion Starter · #4 ·
imported post

Thanks to all, I guess I didn't recognize header connection as an "exhaust pipe joint." Then the low torque made me suspicious, as we need the copper gaskets crushed. :)

Thanks again.
 

·
Premium Member
Joined
·
6,828 Posts
imported post

Tighten until it snaps off then back off a quarter turn! :cheeky1:
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top