Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
16 Posts
Discussion Starter · #1 ·
So i have torn my carbs off a gl1200i due to a float needle (or so i thought) problem. After replacing the float needles and seats i found the problem is the float it self on one carb has pin holes so it fills with gas and sticks.
I cant find floats for sale anywhere......

Could i use crazy glue to seal them...i know it sounds strange but i figure its light wieght and shouldnt of set the balance....


Any thoughts...

D~
 

·
Junior Grue
Joined
·
8,153 Posts
Every parts site I tried lists the floats, part #16013-MB0-671as available although pricey.

You can try the Krazy glue but think about what happens if it flakes off.:eek:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top