Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just purchased a rear speaker kit (w/ fader control) with OEM plugs and wires from J&P cycles for my 1996 1500 Aspencade. Installation went well until I needed to connect the black four prong connecter to the "black rubber boot" (as described in the instructions). I cannot find it anywhere under the seat and looking for any help that someone may offer?

I am attaching a picture of the area for viewing.

Thanks! Motor vehicle Auto part Vehicle Engine Car

Engine Auto part Fuel line Electrical wiring Vehicle
 

·
Premium Member
Joined
·
1,304 Posts
I think you need to buy the extra harness for Aspencades, but it is already in place for SE models.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top