Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
2,795 Posts
imported post

Might have leaky joints at the Rubber Isolators, that connect the carb to the engine manifold... they tend to loose their flexability after a few years, and no longer seal, resulting in a Lean condition (that might appear on just one side, like yours).



Best thing to do is the Replace both of them... Short of that, you can remove both, coat the mating surfaces with K&N Air Filter Grease, then re-install to test.





If that does not work, then start looking for vacuum leaks.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top