Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Administrator
Joined
·
28,231 Posts
Apparently you missed my post on that thread. You 'collapse' the lifters by inserting a small probe in the 'eye' end and then compressing firmly. You should then bleed them back up in a pan of light oil by compressing them while submerged. They'll get stiffer again. They should collapse then a barely perceptible amount...I think the spec is around a couple thousandths. You don't need to remove the head to do any of this, just the valve cover.

:readit: It really pays off to pay attention.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top