Hi
On June 13th I had a dealer remove the rear wheel and put a new tire on. I now have 300 miles on the tire and I have noticed on the center stand in gear the tire does not run true. I placed a t square on the garage floor and along both sides of back tire and on the rotor and none of it runs true. I do not feel any loose play when I try to push tire from side to side or forward and back with my hands. I also notice noise from the final drive when in gear and on the center stand.
We did have a new drive shaft and pinion gear put in about 20,000 miles back.
Do you think the dealer may not have done a proper job on the tire replacement or I may have bad wheel bearings? Is it possible the noise I hear in the final drive is caused by bad wheel bearings.
Thanks
On June 13th I had a dealer remove the rear wheel and put a new tire on. I now have 300 miles on the tire and I have noticed on the center stand in gear the tire does not run true. I placed a t square on the garage floor and along both sides of back tire and on the rotor and none of it runs true. I do not feel any loose play when I try to push tire from side to side or forward and back with my hands. I also notice noise from the final drive when in gear and on the center stand.
We did have a new drive shaft and pinion gear put in about 20,000 miles back.
Do you think the dealer may not have done a proper job on the tire replacement or I may have bad wheel bearings? Is it possible the noise I hear in the final drive is caused by bad wheel bearings.
Thanks
