Steve Saunders Goldwing Forums banner

Hello from Indiana

615 Views 14 Replies 14 Participants Last post by  Rocketman911
Hello everyone,
I am so glad i found this site, I have a 2003 GL1800 that I owned for 10 years, I have always done my own work, And am now needing new suspension, And I wish to do this myself . Just don't know which way to go Or product to use. I wish to stop the dive in the front end and give more support to the rear. I was hoping this would help in the cupping of my tires.:confused:
Thank all
Not open for further replies.
1 - 15 of 15 Posts
welcome to the forums
Welcome from Oklahoma :waving: Enjoy the wing :cheesygrin:

See less See more
Warm welcome to you buddy
Progressive Mono-tubes for the front. Progressive or Traxxion spring for the rear.
41psi front, 42psi rear.
The suspension, IMHO, has little to do w/tire cupping. Under inflation has a large influence on cupping!
You speak of front end dive, does that mean you have shimmed the ADV or does it need cleaned so it works as it's intended to do?
Howdy and welcome to the forum! :waving:

You will get more opinions if you post this over in the Tech Forum.
I tried to reply, Being new I lost my message. so this is a test. To see if it works this time
Hallo Brojim

Welcome on this nice forum. Wish you al the best.
And good luck with your Wing.
Welcome to the forum!:waving::waving::waving::waving:
:waving: :waving: :waving: :waving: :waving: :waving: :waving: :waving:

Hello from Virginia,

Welcome Aboard!!!!!

Glad to have you with us!

:waving: :waving: :waving: :waving: :waving: :waving: :waving: :waving:
1 - 15 of 15 Posts
Not open for further replies.