Honda Deluxe FF headset

820 Views 8 Replies 3 Participants Last post by bamaTrider, Jul 23, 2009

bamaTrider

Discussion Starter · Jun 30, 2009

imported post

I have a Honda (J&M) deluxe headset for a FF helmet. It will not fit either of my current FF helmets because the ear pockets are not deep enough. I didn't want to modify the helmets so I decided to sell the headset. I bought it from a dealer as an open box (no Box) special. It is missing the coil cord. > http://www.directlineparts.com/product.asp?pid=3789&str=4 I mounted it one time in my FF helmet and the speakers pressed on my ears too much. This is a 2006 model, but the current models sell for about $200 on Direct Line.

The model is p/n 08b80-MCA-100 and I'm asking $75, or a decent offer for it. Shipping in the lower US is $5

See less See more

Save

Status: Not open for further replies.

1 - 9 of 9 Posts

Bagmaster

· #2 · Jun 30, 2009

imported post

Can you post a better close up of the cable connector? I may have a full set of the upper and lower cords for it I don't need in case you get a buyer for it.

Save

bamaTrider

Discussion Starter · #3 · Jul 1, 2009

imported post

OK Bagmaster. This is the best I could do on it.

See less See more

Save

Bagmaster

· #4 · Jul 1, 2009

imported post

Ok, what I have is the JA upper cord and the JB lower cord as a set. The pin layout is very close but this one doesn't plug in from the side, it plugs in from the rear with a rubber band keeper on it. Sorry. It also has a plastic pin in the middle between the contact pins.

Save

bamaTrider

Discussion Starter · #5 · Jul 1, 2009

imported post

It takes this headset cord;

http://www.directlineparts.com/product.asp?pid=3789&str=4

Stan

Save

bamaTrider

Discussion Starter · #6 · Jul 5, 2009

imported post

Last call before ebay................

Stan

Save

AMSOILER

· #7 · Jul 5, 2009

imported post

What is a Type III Connector Lead? I have a 95 Aspencade 1500 and my connectors are 5-pin DIN. Can you adapt to that or not?

Save

bamaTrider

Discussion Starter · #8 · Jul 6, 2009

imported post

I'm not sure what the Type III means, but the 5 pin 1 piece cord from my other OF headset works jut fine with it. That's how I checked it to make sure it worked after I bought it. I do know that the small end of the cord needs to be the 90 degree angle type as pictured in the link above.

Stan

Save

bamaTrider

Discussion Starter · #9 · Jul 23, 2009

imported post

Headset is sold.

Stan

Save

1 - 9 of 9 Posts

Status: Not open for further replies.

Top Contributors this Month