Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
4 Posts
Discussion Starter #1
imported post

Has anyone installed a Signal Dynamics "BACK-OFF" brake light module on their GL1800? (I do NOT have the Wig-Wam type). If so, where did you access the brake light 12 volt wire? (Under the seat?Under the rear fender??Etc.) What color is the wire? NOTE: My bike also has the rear trunk spoiler with the red LED light, that also acts as a brake light. Thanks, Barry
 

·
Premium Member
Joined
·
286 Posts
imported post

There is space under the saddle for the backoff unit. You can connect it to the green/red brake wire that is found in the 14 pin grey connector right under the passengers part of the saddle. If you decide to fit it down near the number plate panel where it will get wet and dirty, the green/red wires in the lower connector block is where to connect it.
 

·
Premium Member
Joined
·
3 Posts
imported post

i been looking fo this information for days i'm glad i found it here did not know wehat wire or the best place to put the backoff xp
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top