Steve Saunders Goldwing Forums banner

Kuryakyn risers installed

543 Views 2 Replies 2 Participants Last post by  wingpass
imported post

I had the Kuryakyn risers installed at the local Honda dealer today and when going lock to lock the handlebar on the left touches against the left speaker grill, did anyone else have this problem?
Status
Not open for further replies.
1 - 3 of 3 Posts
imported post

Perhaps you can loosen the handlebar bolts at center and lower (pivot) the bar down just a bit until it does not hit it.

You have an 1800, not sure of the set up on that one. You will have to check it out really good.


Looks like they are fully adjustable, either you can adjust them or take them back and have them do it.

http://www.kuryakyn.com/documents/installation/7437-23GL-0207.pdf

picked this up off another post on the same subject.
imported post

Thanks, your right I think I will take it back to the dealership, so much for the Master tech that has been working there 20 years :doh:. I would do it myself but I don't have the tools.
1 - 3 of 3 Posts
Status
Not open for further replies.
Top