Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Premium Member
Joined
·
1 Posts
Discussion Starter · #1 ·
imported post

I have a LCD im trying to hook up. the wiring is all messede up.

I have all the positives and negs hooked up but Every number letter lights up. kinda how digital dash's on cars do when you first turn them on.

BUT when i wait for it to turn to zero (tach and speedo) it dont. everything just stays lite up. is it suppost to? any help?



Says i have a full tank, tach reads 8888, speedo 888, gears say END i think
 

·
Gregarious Greeter
Joined
·
16,809 Posts
imported post

Is this an after market LCD or an original off another bike?
 

·
Gregarious Greeter
Joined
·
16,809 Posts
imported post

Welcome from the state of Pennsylvania!





 

·
Gregarious Greeter
Joined
·
16,809 Posts
imported post

Need to give way more information, kind of like drawing a picture.
 

·
Premium Member
Joined
·
1,136 Posts
imported post

I don't know anything about the product you are using but often these things have a "test" wire. When this wire is connected to ++ or ground, it causes all of the segments in the LCD to light up, hence the 8888 display. Check carefully to see if you don't have a test lead on the unit. Normally you leave this wire disconnected or perhaps wire it through a pushbutton to test the display. Just a thought.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top