Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Guru
Joined
·
3,074 Posts
imported post

Makes me wonder if a lifter isnt getting partially stuck in its shaft when the metal expands. like its out of round. If that were the case, honning the lifter guide would possibly cure this issue. Did you inspect the bottom of the lifters for mushrooming?
 

·
Guru
Joined
·
3,074 Posts
imported post

If you could grab a different head for the affected side & swap it, you would find out quickly if it's in the valves or the block. If I had a spare I would mail it to you!
Good luck & I really hope it's nothing thats going to cause you problems!
wayne.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top