Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
3 Posts
Discussion Starter · #1 ·
imported post

Recently bought a 78 GL1000 and having a couple of Problems. I'm not a mechanic yet ( going to MMi next month) I cant seem to get the Fuel-Air mix set,1 1/2 turns out and still to rich, is there more than 1 set screw per carb? And My clutch fails when it gets hot, the arm the cable attaches to will go from an Angled Position to a Straight Up Position and the Lever stays at the Handlebar. Any info would be HIGHLY Appreciated.
 

·
Premium Member
Joined
·
10,253 Posts
imported post

I can only say it takes guages to set the carbs, but one of our Guru's will be along shorty to answer all your questions...Good luck with the MMi school????..OH and Welcome to the Forum...
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top