Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
2 Posts
Discussion Starter #1
imported post

Hi all, I just recently picked up a 1984 GL1200 Aspencade project bike, and was browsing the web for some insight, and I ran across this site. It sure looks like theres a wealth of info here. I have absolutely no experiance with a goldwing, and am attempting pretty much a complete restoration on this GL1200. Does anyone know the piston size in these motors? My bike has some rust in the cylinders, and I was considering boreing to a size over to correct the cylinder problem. Anyone have any experiance with this, or advice? Any and all would be appreciated.
 

·
Premium Member
Joined
·
427 Posts
imported post

There is a site run by Vic Belanger which is dedicated to GL1200's. Between this site and Vic's there shouldn't be any questions which can't be answered by very knowledgeable members. Have a look at www.gl1200goldwings.com
 

·
Premium Member
Joined
·
100 Posts
imported post

Duncan,

Welcome to the forum. :waving:

This site is a wealth of information...I sometimes just look through the topics just to learn more about problems that I might incur.



Good Luck and have fun with your new "toy"



Cerfer
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top