Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 16 of 16 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
hi wing riders question i was replacing belts and I noticed when i put tensioners in place pullys moved i rotated crank around back to marks several times marks still off what do I do next to correct this pullys in up position crank on mark on engine but pullys off any advice
 

·
Gregarious Greeter
Joined
·
16,809 Posts

Welcome:waving:MilesF6
 

·
Premium Member
Joined
·
28,832 Posts
Welcome, Welcome from Clermont, Indiana
You should really post this on the Goldwing Technical Forum that is where all the Goldwing repair GURU's hang out and will help you with anything and everything.
 

·
Premium Member
Joined
·
74,592 Posts
Hallo MilesF6

Welcome on this nice forum. Wish you al the best.
And good luck with your Wing.
 

·
Premium Member
Joined
·
8,921 Posts
Welcome from Oklahoma :waving: Enjoy the wing :cheesygrin:
 

·
Premium Member
Joined
·
1,462 Posts
 

·
Premium Member
Joined
·
14,148 Posts
I recommend you post your question over in the technical section. Most of the gurus won't see it over here, and a lot more people frequent over there. Just a few of us greeters hang out over here on a regular basis.

:waving: :waving: :waving: :waving: :waving: :waving: :waving: :waving:

Hello from Virginia,

Welcome Aboard!!!!!

Glad to have you with us!

:waving: :waving: :waving: :waving: :waving: :waving: :waving: :waving:
 
1 - 16 of 16 Posts
Status
Not open for further replies.
Top