Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
1,489 Posts
Discussion Starter #1
imported post

With black rubber o'rings. These are for aftermarket gl crash bars with mounting brackets welded on. $20 plus exact shipping. Gwrra 353
 

Attachments

·
Premium Member
Joined
·
477 Posts
imported post

I was thinking of making a set of these to replace the boards I have.
(One is mysteriously cracked after some yo-yo tipped over his bike in the garage....) :ssshh:
Don't know how I did it, but I found out I don't want to do it again!!

Anyway, if you'll figure a total with shipping to 99114, I would take those off your hands if they're still available.

Thanks,
Jim

[email protected]
 

·
Premium Member
Joined
·
31 Posts
imported post

(One is mysteriously cracked after some yo-yo tipped over his bike in the garage
LOL, that guy gets around, probably same one that knocked mine over in a parking lot...with me on it. I ended up cracking my floorboard as well, luckily being a weldor by trade I was able to fix it. Hardest part was getting the 'E' clip off the end of the pivot shaft which I replaced with a long s/s bolt and acorn nut.

If you want to pay for shipping I could more than likely fix yours n/c....Mike
 

·
Premium Member
Joined
·
1,489 Posts
Discussion Starter #4
imported post

Sold. Thanks Jim :
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top