[johnboy]

imported post

i went to www.southernhonda.comand used their parts fiche. item #35 in the cylinder block shows a seal. 14X28X7 p/n 91206-286-013 i think this is the correct seal. measure the seal inner and outer dimension. if it is 14X28 then this is most likely the correct seal. the selling price was $2.47 so it's not that expensive.a local bearing house could also match up this seal with these dimensions.

cheers john

 

[johnboy]

imported post

:waving:dug through the old parts i saved when i was doing repairs on my 1200. the seal size is as stated in my previous post. i used a 4" wood screw into the side of the seal to pull it out.

cheers john