Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello all,

I have a plexistar 2 windshield made by National Cycle, Inc on my '76 GL1000. I have been looking for some kind of venting system for it with no luck. I know its easily removed and replaced but I start work at night while its cold and return when its warm again. Any help would be delightful and sorry if this is a repost.
 

·
Premium Member
Joined
·
12,868 Posts
Hello and Welcome to the forum . I am not familiar with the windshield you have . Perhaps a pair of Vetter snap vents could be installed . Here is a link to the Vetter fairing parts page . scroll down to the snap vetns . They require a hole be frilled for each vent .
link : Online Store: Replacement Vetter Parts

I hope this is able to help you . Enjoy your ride .
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks friend, I think that might be the only way I could go unless I search store by store and find something that has the same curve. I doubt anyone would have a variety of vents :/

'Merica!
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top