Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Premium Member
Joined
·
325 Posts
Discussion Starter · #1 ·
imported post

I thought I understood what I was doing but now I'm wondering.:?



I decided toprovide the power to the grips from the Accessory terminal on the left side fuse block. There is a + terminal side and a - terminal sideso I assume I can just connect to either side? Is that correct? The terminal is 5 amp. Originally I thought theminus side meant it was a ground but I don't think that is the case.



If I don't use the accessory terminal where is there power in the front of a 1500 I can use? Some day I may add an extra fuse block but at this point my needs are simple.......I just want to keep my hands warm!



Thanks in advance.
 

·
Premium Member
Joined
·
325 Posts
Discussion Starter · #5 ·
imported post

Thanks Dave. I thought so but was having a brain cramp.
 

·
Premium Member
Joined
·
325 Posts
Discussion Starter · #7 ·
imported post

New day the Grip Heaters are supposed to be about 3+ amp draw. My idea was to get heat to my hands but if I popped fuses I'd add a relay. The wires are so small on the heaters, either 18 or 20 ga I couldn't imagine them taking much amperage. The next step if I add anything else would be to add additional power like what Rudy had Dusty Boots have recommended. I guess Rudy's kits are no longer available though.
 

·
Premium Member
Joined
·
325 Posts
Discussion Starter · #9 ·
imported post

Thanks Dusty for clarifying that. It looked like there was some sort of kit in one of the threads I read that had all the connectors etc. ready to install.
 

·
Premium Member
Joined
·
325 Posts
Discussion Starter · #12 ·
imported post

Got my grips installed along with an aux port for my cell phone charging on longer trips. It's been raining for 3 days here in the NE but I cranked up the bike in the garage, (plenty of ventilation from the exhaust) and the grips heat up, even thought they are the Kury fat ones. I wanted to see what the current draw was but couldn't get a reading? I had the multimeter on the low 10 amp scale, and pulled out the fuse in the external fuse holder I added. I then stuck the two probes in where the fuse was so the meter was in the circuit. It justs read 0 but the grips heated up so I know they are working. I thought I understood some basics of electricity but I'm scratching my head!:?
 

·
Premium Member
Joined
·
325 Posts
Discussion Starter · #14 ·
imported post

It's got to be something simple. I was scratching my head,.....even did the unspeakable, got out the manual for the multimeter to make sure I wasn't overlooking the obvious but I must be!
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top