Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Junior Grue
Joined
·
8,153 Posts
'87 Interstate.
I can't bring up the fiche, but which seal is needed if the slave is leaking?
There are two showing on the fiche. Numbers 13 & 14.
Although you don't say I take this is the clutch slave cylinder.

And again you don't say what is leaking.
If it's oil you need seal #13.
If it's hydraulic fluid you need cup #8.
 

·
Junior Grue
Joined
·
8,153 Posts
Thanks, Redwing. I suspect you're right.
Actually Redwing is incorrect.
Seal #14 is there to keep grease in and moisture out of the interface between the piston and push rod.
If you're leaking hydraulic (brake) fluid you need piston cup #8
Bike...and Dennis said:
Ken, are there other slave cylinders on the 12?
Only six others that I can think of off the top of my head.:ROFL:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top