Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
123 Posts
Discussion Starter #1
imported post

Before I had got the info on the redoing the calipers, I had allready removed them. Now I might have toput them back on and bleed it. Will they compress same as an auto.
 

·
Registered
Joined
·
2,129 Posts
imported post

I use a C Clamp or a pair of welding vise grips.

But be careful you don't compress them too much.

Going past where the pistons normally ride will tend to scratch or distort the seals or pistons.

Good Luck

Mohawk
 

·
Premium Member
Joined
·
76 Posts
imported post

If the piston did not leave the caliper bore(would start to leak) it will be ok to just compress the piston back into place being careful not to damage the piston external seal. It should be just like pressing an auto piston caliper.
 

·
Premium Member
Joined
·
123 Posts
Discussion Starter #4
imported post

GREAT>>>>thats what I wanted to hear...Thank's
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top