Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Premium Member
Joined
·
9,790 Posts
Discussion Starter #1
imported post

question, When putting the rear wheel driven flange back on my 1200 do I need to coat the tappons (spelling?) with anything or do they just go back in dry and clean?

Thanks in advance, Ray

:action:
 

·
Premium Member
Joined
·
3,344 Posts
imported post

i asked the same question a couple of week ago, some said grease and some said dont grease,my spindles was bone dry and never looked like ever seen grease, i cleaned them up and put a light smearing of moly 60 on them
 

·
Premium Member
Joined
·
9,790 Posts
Discussion Starter #3
imported post

Thanks, Mine was the same way and a PITA to get off without damaging anything:shock:

I will put a lite coat of moly on and be happy :)

Thanks Again, Ray

:waving:
 

·
Premium Member
Joined
·
10,276 Posts
imported post

Mine were dry as a bone on my 86. I didn't feel right putting it back together dry, so I also put a light coating of moly grease on it.
 

·
Premium Member
Joined
·
9,790 Posts
Discussion Starter #5
imported post

Thanks Mike:waving:
 

·
Premium Member
Joined
·
1,624 Posts
imported post

As above, defiantly moly 60 on them. :waving:
 

·
Premium Member
Joined
·
9,790 Posts
Discussion Starter #7
imported post

THanks AVA Auto Tech:waving:
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top