Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
50 Posts
Discussion Starter · #1 ·
imported post

been looking at the removal of headlight on 82 GL1100, that nut thats behind the gages sure don't leave much room to take nut off. Would I have to take fairing off to get nut off? what have most of you folks used a socket or open wrench? what size socket do you know off hand what it takes? is there any tips about getting nut off. thanks
 

·
Premium Member
Joined
·
50 Posts
Discussion Starter · #3 ·
imported post

thanks k1w1t1m, I won't have to mess with set screw and knob it doesn't have one on. just the shaft with nut. I can see where set screw goes in if it had a knob. thanks Terp
 

·
Premium Member
Joined
·
50 Posts
Discussion Starter · #4 ·
imported post

you guys use a stubby wrench when taking off nut to let headlamp out. I tried with a regular wrench, you can't hardly move around. I'll have to buy a stubby and see if that works.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top