[jsmith24]

imported post

Hi all,

I just gota set of killer Wingleader rotor covers for my GL1100 as a present to the old girl (and myself) for having wrecked her a few weeks back. The set is used, and with the help of Mr.1200, who provided a copy of the old instructions, I find that I need an axle spacer.

Mr.1200 informs me that the correct spacer would have a length of 3/4 inch, and that I should have mine machined down. I can do that, of course, but I would feel better if I could keep the original and either machine another factory one down to size, or if anyone happens to have an old Drag Specialties axle spacer, as used in their rotor covers, I would greatly appreciate it.

OR, if you just know where I can find one, I'd still be appreciative. I've already checked with Honda, and it (and its upgraded replacement) are no longer available.

Thanks for any and all help!

Jack

 

[wingdawg101]

imported post

You can try these two salvage yards...

#1 in Hoschton,Georgia.. 770-867-1281

#2 in St. Paul, Minn.... 800-522-7891

or oldbikebarn.com

 

[RedWinger]

imported post

 

[Heffo]

imported post

You can buy bushes or get them made to order from such places as these;

http://www.southerntemp.co.uk/plascomp.htm

Just give them the measurements of the one you want made and that's it.

 

[wingwarrior]

imported post

http://www.cmsnl.comtry this place

 

[jsmith24]

imported post

Hi all,

I finally found an axle and spacer on eBay, then had a local retiree machine it down to spec for me. Thanks again for all the help!

Jack