Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Premium Member
Joined
·
6,278 Posts
Discussion Starter #1
imported post

:)iam going to replace, the T section of the fairing,in between the headlights on the 1800,, with a chrome one,,,, on inspection today,, what ever holds it in place, in the two holes either side is missing,, could some one tell me are they plastic rivets or screws:baffled: cheers pp,
 

·
Premium Member
Joined
·
5,502 Posts
imported post

Directly between and below the headlights, plastic section about a foot long and viewed from the front looks like an upside down T? That one ? I is secured with screws.

Kit
 

·
Premium Member
Joined
·
6,278 Posts
Discussion Starter #3
imported post

:)Thanks Kit,, ;)
 

·
Premium Member
Joined
·
10,276 Posts
imported post

If it were my 1800, I would use a huge piece of Duct tape.........;)
 

·
Premium Member
Joined
·
913 Posts
imported post

mikef wrote:
If it were my 1800, I would use a huge piece of Duct tape.........;)
Duct tape being used on 1200's now that parts are getting scarce,Could be 1500's are next.....then the 1800's:cheeky1:................
 

·
Forum Diplomat
Joined
·
7,368 Posts
imported post

Super-glue....... dusted with sprinkles!

:cool::cool::cool:

(I think I need a hobby........)

:(
 

·
Premium Member
Joined
·
6,947 Posts
imported post

Just use a big wad of bubble gum in each corner. ;)
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top