[Hardanger]

I had problem with compression on my GW 1200 -84. Cylinder 1,2,3 had 11,5 bar no 4 -9, 8 bar. I dismantled cylinder tob and lapet valve and valvseat. After mounting i have bad running. Timing belt are corekt. The engine are misfiring?? It runs bad on idling. I have don reasembly according too Clymet book without sumerg hydraulic lifters in keroosin/oil??

 

[Hardanger]

Have you rechecked the compression after reassembly?

The compression is the same than before.

 

[Hardanger]

The engine was running nice before dismantling?
Howe importen is it to sumege the hydraulic lifter before mounting??

 

[Hardanger]

The lifters should pump up on their own, it just might take a while. Are you having a lot of valve train noise?
If it ran fine before you took it apart, and now it doesn't, obviously my first thought is you made some mistake. Go over everything you did and start at the basics.

Hi
There are not any valve train noise.
What are the consequences with to litle ore to many shims on the hydraulic lifters??? I have checked the measurement and all lifters are under minimum.

 

[Hardanger]

Too little shim gets valve train noise, too much stops the valve from closing completely.

I wil try to remove al shims on the valves in the top I have done some work on.There are not any valvtrain noise