[JohnnyW]

imported post

I think the subject and description says it all. Particularly 1 and 2 are very hard to get at. I did a little looking for one of those mechanical offset screwdrivewrs I've seen in the past as I think this would turn the trick if it's the right length. What are y'all using to get at these? Source for purchase also very appriciated! Thanks.



Johnny

 

[RB]

imported post

Go here scroll down

http://tinyurl.com/kvc9t9

also tools for synch listed

 

[JohnnyW]

imported post

Awesome RB, though I found better prices through Pit Posse. I have a mercury mamometer already. I just think they're more accurate than guages. As long as I was putting in an order, I also decided to get a sync tool as well. Both ran me $42.85 shipped ground to NY. Not too shabby. Boy do I appriciate the lighning fast reply too, RB! The wait for shipping is no bother. Actualy I want to set my valve lashes before I do the pilot screws and sync anyhow. I'm a happy camper. Thanks again!

Johnny

 

[sandcastcb750]

imported post

How can you adjust those screws with the caps on? They stop at 3/4 turn.

 

[Bagmaster]

imported post

sandcastcb750 wrote:

How can you adjust those screws with the caps on? They stop at 3/4 turn.

Those caps are made of plastic or in some cases lead. A quick shot to them with a small propane torch with make them fall right off.

 

[JohnnyW]

imported post

sandcastcb750 wrote:

How can you adjust those screws with the caps on? They stop at 3/4 turn.

Brand new screws. No caps. :action::dude::clapper: