Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Premium Member
Joined
·
2,790 Posts
easiest way to explain is to put two nuts onto stud,with a 10mm wrench holding one,take the upper one with another wrench and tighten both together,continued motion (clockwise) against the upper nut should start to back the stud out of the head

once the starter is pulled out it takes a little bit of twisting and turning at the right time to get it out of the mc in the confined space,hard to explain

just make sure your battery is disconnected
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top