Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Premium Member
Joined
·
61 Posts
Discussion Starter #1
imported post

yesterday i put my 15 in reverse the neutral light went out as i should and the reverse indicator came on i reversed the bike and left it for a while now the bike wont start on the button no neutral light either.any ideas lads (everything else works) after a push start
 

·
Premium Member
Joined
·
395 Posts
imported post

That happened to me too. On mine, one of the wires had come of the reverse lever switch. It looked to be still connected, but it was held by just a strand of insulation and as soon as I touched it, it fell off.

You have to peel back the rubber on the reverse lever and remove the bolt. I think I had to take the plastic side cover it comes through off too. Worth a check as I tried everything else first!. Good luck Steve
 

·
Senior Guru
Joined
·
3,873 Posts
imported post

remove the cover for the oil dipstick and the linkage is in there may have sliped off the pully
 

·
Senior Guru
Joined
·
3,873 Posts
imported post

yes because its not turning off the reverse electric system if it reads its still in reverse it wont start or turn over
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top