[JamesPal]

imported post

I'm pulling my swing arm tomorrow. The Honda factory shop manual is not clear about the swing arm bearing grease spec. I have Moly 60 for the splines. Is a general grease OK? I will also be greasing the brake pedal pivot.

 

[vtxcandyred]

imported post

JamesPal wrote:

I'm pulling my swing arm tomorrow. The Honda factory shop manual is not clear about the swing arm bearing grease spec. I have Moly 60 for the splines. Is a general grease OK? I will also be greasing the brake pedal pivot.

Not sure about the swing arm. I would use a waterproof type. I use nickle graphite grease on the brake sliders. Any sliding parts on the brakes, minus the pads ofcourse, gets it. I use this on the battery terminals.

 

[Dusty Boots]

imported post

A quality wheel bearing grease will be fine. Just make sure you pack the new bearings good 1st.