Steve Saunders Goldwing Forums banner

1 - 6 of 6 Posts

·
Registered
1985 - GL1200 Aspencade (a mere "baby" at 35K miles)
Joined
·
7 Posts
Discussion Starter · #1 ·
I must be loosing it!!
I can't find any where the size of the bloody o-rings for the air, fuel, and vacuum tubes for my '85 Wing Aspencade.
The ID I measure on the old one is darn close to 6mm
I found these on Randakks page.

323390
 

·
Registered
Joined
·
518 Posts
Honda rarely list sizes and just sell "kits" if you buy a kit you can then measure them for future reference
 

·
Registered
1985 Honda Goldwing Interstate
Joined
·
3 Posts
How about the o-ring between each carburetor and the airbase? I cannot find those anywhere. Does anybody here know the specs of that?

Thanks.
 
1 - 6 of 6 Posts
Top