Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Premium Member
Joined
·
160 Posts
Discussion Starter #1
imported post

I've milled out a couple of electric fuel pump block off plates for my old bikes.

They're basically a plate that covers the hole in the motor and seals it off, then extends up so you can mount an electric pump on it.

I can make them with or without holes to mount your existing pump.

Here's a not so great pic of one. Using this with an electric pump was a lifesaver. This will be one of the first mods I do to any new/older bikes I get.

I have extra material and wouldn't mind turning a few out to sell them on here or on ebay.

What would you pay for one of these? Is it even worth the time to set the mill back up?


Thanks
 

Attachments

1 - 1 of 1 Posts
Status
Not open for further replies.
Top