Steve Saunders Goldwing Forums banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
134 Posts
Discussion Starter #1
I am installing new wheel dampers on the rear wheel, the question is how to I compress them enough to get the retaining ring started? 93 GL1500
 

·
Premium Member
Joined
·
134 Posts
Discussion Starter #2
I got it, I ground ramps on the edge of the starting tabs, it didn't want to go but finally gave up and went in. I used a brass punch to turn it.
 

·
Premium Member
Joined
·
3,543 Posts
I got it, I ground ramps on the edge of the starting tabs, it didn't want to go but finally gave up and went in. I used a brass punch to turn it.

When I replaced them on my '99 I didn't need to do any of that..... Were you holding your mouth just right......:laugh:
 
1 - 4 of 4 Posts
Top