Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Itinerant Wing Preacher
Joined
·
875 Posts
Discussion Starter #1
imported post

I need the idle air adjustment screw out of an 83. One of mine has a sheared off head. They are different thae the ons on my 81. Thw have a head with a tab to limit the adjustment. Thanks jay
 

·
Administrator
Joined
·
26,561 Posts
imported post

All of them have the tab from the factory, it is glued on. You have to heat them and they will come off. All 1100 adjustment screws are the same. I have some I think.
 

·
Itinerant Wing Preacher
Joined
·
875 Posts
Discussion Starter #3
imported post

The stops have been removed from my bowls, and the tab actually seems to be easier to turn than the very small screw heads. If you have some let me know. Jay
 

·
Administrator
Joined
·
26,561 Posts
imported post

PM me your address and I'll dig one up tomorrow.
 

·
Piled Higher and Deeper
Joined
·
4,513 Posts
imported post

I just cut a slot in the remaining part of the screw...
 

·
Piled Higher and Deeper
Joined
·
4,513 Posts
imported post

(slow today.. so hit it again..):?
 

·
Itinerant Wing Preacher
Joined
·
875 Posts
Discussion Starter #7
imported post

sandiegobrass wrote:
I just cut a slot in the remaining part of the screw...
Thats how I got the old one out, I just can't see my fat fingers and a screwdriver in that spot. Jay
 

·
Registered
Joined
·
10,509 Posts
imported post

They can also be bought new through some bike shops. I bought 1 for my Brothers 83 when he broke one off flush with the carb.

I think it was just 12 bucks and was for a different bike but it work.

Randakk's website can tell you what bike it's for.
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top