Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
11 Posts
Discussion Starter #1
imported post

I'm having a problem with the seal behind the windshield pushing out on each end. I took it out and cleaned all the old adhesive off of the seal and the trim too and replaced with contact cement but it won't hold it. Does anyone have a suggestion as to what kind of adhesive would hold this on? Thanks in advance.
 

·
Premium Member
Joined
·
1,028 Posts
imported post

Is this on a GL1500? If so, get some 3M double sided tape (the stuff for holding side trims on cars). That will hold the trim in place.
 

·
The Irish Crew
Joined
·
3,932 Posts
imported post

Make sure as well that you don't over stretch that seal, otherwise the ends will not sit properly and will stick out over the ends of the windshield garnish.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top